Gate TITAN V2 ADVANCED *REAR Wired* Firmware Drop-In Programmable MOSFET TTN2-AMR0

Gate TITAN V2 ADVANCED *REAR Wired* Firmware Drop-In Programmable MOSFET TTN2-AMR0

$139.95
(No reviews yet) Write a Review
 

GATE Control Station™

TITAN and GATE Control Station give you total control of your AEG. The GCS offers you the option to:

  • control your airsoft gun from smartphone with Android and PC with Windows or macOS
  • simply adjust the TITAN’s settings
  • update and upgrade firmware
  • see the Statistics and participate in Rankings*
  • perform diagnostics and send reports
*only in case of Advanced firmware

 

 
 

Settings

TITAN gives you the option to adjust:

  • Fire selector mode
  • Pre-cocking mode
  • Pre-cocking boost
  • Burst mode
  • Burst
  • ROF Stabilization
  • ROF Control
  • Sniper Delay
  • Battery protection
  • Battery cell
  • Low battery warning
  • 30-rounds limit
  • Cycle detection
  • Equalizer (dynamic trigger point)
  • Active Brake
  • Gear ratio

Please note that the BASIC firmware edition does not support all the functions 
 

Statistics

TITAN gives you the option to check:

  • Rate of fire
  • Trigger response
  • Module's temperature
  • Motor current
  • Battery voltage
  • Number of fired BBs
Minimum, Average, Maximum
Minimum, Average, Maximum
Minimum, At this moment, Maximum
Average AUTO, Average SEMI, MAX PEAK
Minimum, Last, Maximum
BB1, BB2, TOTAL

Please note that the BASIC firmware edition does not support the Statistics 

 Thanks to the gear sensor you get:

  • Automatic BURST – there is no need to set burst time. You can set burst between two and 10 shots;
  • Automatic PRE-COCKING – pre-cocking is fully operational in SEMI, BURST and AUTO mode and there is no need to set pre-cocking boost manually. You can easily set the pre-cocking as high, mid or low;
  • FULL CYCLE - when the pre-cocking is off, TITAN ensures that the gearbox always makes full cycles.

You can trust TITAN because:

  • Every time you pull the trigger, gearbox completes the correct cycle. The gears stop exactly where they should. The gearbox works efficiently.
  • It is protected against short-circuits, overheating and overloading
  • It protects the battery against over-discharge
  • It significantly improves battery life, rate of fire, spring life and gearbox reliability (when pre-cocking is off)
  • It is compatible with the strongest AEG replicas and batteries (ready to use with LiPo 14.8V, 5000 mAh, 60C)

Related Products

!